Basement Waterproofing
Matt Shapiro - Pennfield, NY

Hardwarian Matt Shapiro

Beyond Hardware

Pennfield, NY

Basement Waterproofing

Level: Experienced

One of the most frustrating problems faced by homeowners is the constant battle against wet basement walls. Luckily, basement waterproofing is a do-it-yourself project you can finish with a little time and effort.

Waterproofing protects basement walls and other masonry surfaces from the damaging effects of water penetration. It seals porous masonry walls above and below the ground level, penetrating the masonry's tiny pores to form a watertight coating. This stops leaks and holds back the flow of water, even under pressure, and helps keep basements dry.

Share this project
Print
Project Steps
Project Shopping List
    • Step 1: Find the Source of the Problem
       

      A wet basement wall might be a symptom of a larger problem. Water may be coming in from a variety of sources — leaky downspouts or gutters, blocked drainage pipes, improper grading or ruts that direct ground runoff toward your foundation. Correcting these problems, along with waterproofing your basement walls, is the best way to prevent masonry surfaces from leaking.

      You should find out if seepage or condensation is causing your wet walls. To test this, tightly tape a one-foot square of aluminum foil to an interior basement wall, removing it after several days. If the room side of the foil is wet, the problem is condensation. Using a dehumidifier in your basement should help get rid of condensation. If the wall side is wet, the problem is seepage. Both problems can occur at the same time.

      Another source of water seepage could be an area often times overlooked — the floor/wall joint. When concrete floors cure, they shrink and pull away from the wall, allowing a space for water to enter. Seal all gaps between floor and walls with hydraulic cement.

    • Step 2: Surface Preparation
       
      muriatic acid

      Just like any painting job, surface preparation is a critical step. Loose or broken mortar, dirt, dust and other debris should always be removed before putting on a new coat of paint.

      Before applying the waterproofer, clean the surface thoroughly. Waterproofing works best when applied to a clean, bare masonry surface.

      To remove old paint, use a wire brush or sandblast the surface. Use muriatic acid to get rid of efflorescence—the white, crystal-like salt deposits that will prevent the waterproofer from sticking to the wall. Any holes should be patched with hydraulic cement.

      Safety Alerts!

      Muriatic acid is highly corrosive and can be harmful to your skin. Wear protective clothing, safety goggles and protective gloves when working with muriatic acid.

      The fumes from muriatic acid can also be harmful. Be sure you're working in an area with

      Muriatic acid can also damage other surfaces. Take care when applying the muriatic acid to walls.

    • Step 3: Apply the Waterproofer
       
      water proofer

      Now that you've prepped the surface, you're ready to apply waterproofer to your basement walls. For best results, apply the first coat with a nylon or polyester bristle brush. The second coat can be applied with a brush or masonry roller. Work waterproofer thoroughly into the pores of the masonry. After using the first gallon, measure the area covered. It should be about 75 to 100 square feet. If the area is more than this, you're spreading the waterproofer too thin.

      Apply a second coat over the entire wall surface. If seepage is still present after several days, tiny pores or pinholes are still open. Apply an additional coat to these areas.

      Helpful Tip

      Waterproofer won't adhere to a wall with a temperature less than 50ºF.

      Most waterproofers aren't made to withstand foot traffic, so don't try to waterproof your basement floors.

      Congratulations! You've just waterproofed your basement, a do-it-yourself project that will help keep your basement dry for years to come.

  • Here’s what you’ll need to complete this project successfully.

    Before you begin, use the shopping list below to uncheck the tools you already have to complete this project.

    Then, print or save your updated list and bring it to your local True Value hardware store, where an expert Hardwarian will give you the remaining tools and expert advice you need to complete this project.

    You can also shop online for these project items at TrueValue.com and receive FREE shipping to a participating store.

    60 character limit.
  • Alternative Mulch Landscaping Ideas

    There are a number of mulch alternatives to consider.

    Learn More

  • Top Spring Projects

     
  • How to Make Compost

    Learn how to make compost for your lawn and garden.

    Watch Video

  • Follow Us On Pinterest

    Follow Us On Pinterest

    Visit our Pinterest page for great do-it-yourself project advice and home inspiration.

    Follow Us

  • Behind Every Project Is a True Value

    Behind Every Project Is a True Value

    Get the projects and advice you need to get your projects done right.

    View Commercial